Preparation of Silica Adsorbent from Tin Tailing Sand by Alkali Fusion–Acid Leaching for Methylene Blue Removal

Authors

  • GadistaAmandaPutri Putri Universitas Bangka Belitung
  • Yuant Tiandho Universitas Bangka Belitung
  • Yoza B. P. S. Putra Universitas Bangka Belitung

Keywords:

Silica, Tin Tailing, Wastewater

Abstract

The valorization of mining waste into functional materials provides a sustainable approach to environmental remediation and resource utilization. This study investigated silica recovered from tin tailing sand via an alkali fusion–acid leaching process as a low-cost adsorbent for methylene blue (MB) removal. Batch adsorption experiments were conducted using 50 mL of 10 mg/L MB solution with silica dosages ranging from 0 to 1.0 g. Residual MB concentration was determined by UV–Visible spectrophotometry at 664 nm, while turbidity measurements were performed to evaluate the effect of suspended silica particles. Adsorption performance strongly depended on adsorbent dosage, with the highest removal efficiency (98.32%) achieved at 0.2 g of silica. Increasing the dosage beyond this optimum did not improve MB removal, with efficiencies ranging from 90.55% to 97.78%, accompanied by a marked increase in turbidity. This behavior indicates that excessive silica loading promoted particle aggregation and suspended fine particles, reducing the accessibility of adsorption sites. These findings demonstrate that silica derived from tin tailing sand is an effective adsorbent for methylene blue removal and emphasize the importance of optimizing adsorbent dosage to maximize adsorption efficiency while minimizing suspended solids, supporting the sustainable utilization of tin mining waste for wastewater treatment.

ABSTRAK

Pemanfaatan limbah pertambangan menjadi material fungsional merupakan pendekatan berkelanjutan untuk mendukung pemanfaatan sumber daya dan pengendalian pencemaran lingkungan. Penelitian ini mengkaji pemanfaatan silika hasil ekstraksi pasir tailing timah melalui proses fusi alkali–pelindian asam sebagai adsorben berbiaya rendah untuk menghilangkan metilen biru (MB). Uji adsorpsi dilakukan menggunakan 50 mL larutan MB 10 mg/L dengan variasi dosis silika 0–1,0 g. Konsentrasi MB sisa dianalisis menggunakan spektrofotometer UV–Vis pada panjang gelombang 664 nm, sedangkan kekeruhan diukur untuk mengevaluasi pengaruh partikel silika tersuspensi. Kinerja adsorpsi sangat dipengaruhi oleh dosis adsorben, dengan efisiensi penyisihan tertinggi sebesar 98,32% pada dosis 0,2 g. Peningkatan dosis di atas kondisi optimum tidak meningkatkan penyisihan MB (90,55–97,78%) dan diikuti oleh peningkatan kekeruhan yang signifikan. Hasil ini menunjukkan bahwa penambahan silika berlebih menyebabkan agregasi partikel dan meningkatnya partikel halus tersuspensi sehingga mengurangi aksesibilitas situs adsorpsi. Temuan ini menegaskan bahwa silika dari tailing timah berpotensi sebagai adsorben efektif untuk pengolahan air limbah, dengan optimasi dosis menjadi faktor penting untuk memperoleh kinerja adsorpsi yang maksimal.

References

Awual, M. R. (2019). A facile composite material for enhanced cadmium (II) ion capturing from wastewater. Chemical Engineering Journal, 359, 639–647. https://doi.org/10.1016/j.cej.2018.11.176.

Crini, G., & Lichtfouse, E. (2019). Advantages and disadvantages of techniques used for wastewater treatment. Environmental Chemistry Letters, 17(1), 145–155. https://doi.org/10.1007/s10311-018-0785-9.

Crini, G., Lichtfouse, E., Wilson, L. D., & Morin-Crini, N. (2019). Conventional and non-conventional adsorbents for wastewater treatment. Environmental Chemistry Letters, 17(1), 195–213. https://doi.org/10.1007/s10311-018-0786-8.

Foo, K. Y., & Hameed, B. H. (2010). Insights into the modeling of adsorption isotherm systems. Chemical Engineering Journal, 156(1), 2–10. https://doi.org/10.1016/j.cej.2009.09.013.

Gupta, V. K., & Suhas. (2009). Application of low-cost adsorbents for dye removal—A review. Journal of Environmental Management, 90(8), 2313–2342. https://doi.org/10.1016/j.jenvman.2008.11.017.

Kalapathy, U., Proctor, A., & Shultz, J. (2000). A simple method for production of pure silica from rice hull ash. Bioresource Technology, 73(3), 257–262. https://doi.org/10.1016/S0960-8524(99)00127-3.

Yagub, M. T., Sen, T. K., Afroze, S., & Ang, H. M. (2014). Dye and its removal from aqueous solution by adsorption: A review. Advances in Colloid and Interface Science, 209, 172–184. https://doi.org/10.1016/j.cis.2014.04.002.

Downloads

Published

2026-10-31