PEMANFAATAN LIMBAH SERAT TALI BENESER DALAM MENINGKATKAN KUAT TEKAN DAN KUAT TARIK BELAH BETON

Authors

  • Afifah Agnia Universitas Negeri Jakarta
  • Universitas Negeri Jakarta
  • Universitas Negeri Jakarta

DOI:

https://doi.org/10.21009/jmenara.v16i2.19401

Keywords:

fiber concrete, wasted fiber rope, strapping band, compressive strength, tensile strength

Abstract

This study aims to determine the utilization of fiber rope waste (strapping band) in increasing the compressive strength and tensile strength of concrete with fiber cross-section size of 2-3 mm and length of 60 mm with variations in the addition of 0 kg/m3, 0,25 kg/m3, 0,5 kg/m3, 0,75 kg/m3, and 1 kg/m3concrete .the compressive strength of the plan is 30 MPa. The specimen is cylindrical size 150 mm x 300 mm with concrete making planning refers to SNI 03-2834-2000. The results with the addition of rope fibers (strapping band) shows the compressive strength of variations 0 kg/m3, 0,25 kg/m3, 0,5 kg/m3, 0,75 kg/m3, and 1 kg/m3respectively are 12,55 MPa, 8,87 MPa, 16,608 MPa, 11,418 MPa and 12,644 MPa with the optimum value of concrete compressive strength of 16,608 MPa at variations of the addition of 0,5 kg/m3of fibers. Thus from all the compressive strength values obtained, there are no concretes that reaches the compressive strength of the plan. Whereas the results of tensile strength test are 1,42 MPa, 0,8 MPa, 1,35 MPa, 1,06 MPa and 1,13 MPa respectively with the optimum tensile strength value of 1,53 MPa in variations of addition of 0,5 kg/m3 fibers.

References

Badan Pusat Statistik. (2018). Statistik Lingkungan Hidup Indonesia 2018. Badan Pusat Statistik (BPS). https://www.bps.go.id/publication/2018/12/07/d8cbb5465bd1d3138c21fc80/statistik-lingkungan-hidup-indonesia-2018.html

Felany, D. (2004). Tinjauan Kuat Desak dan Kuat Tarik Belah Beton dengan Penambahan Serat Tali Beneser.

Hasanr, H., Tatong, B., & Tole, J. (2013). Pengaruh Penambahan Polypropylene Fiber Mesh Terhadap Sifat Mekanis Beton. Majalah Ilmiah Mektek, 12–19.

Khairizal, Y., Kurniawandy, A., & Kamaldi, A. (2015). Pengaruh Penambahan Serat Polypropylene Terhadap Sifat Mekanis Beton Normal. Jurnal Online Mahasiswa Fakultas Teknik Universitas Riau, 2(2), 1–11.

Lestari, I. G. A. A. I. (2013). Perbandingan Perkerasan Kaku dan Perkerasan Lentur. Jurnal Transportasi, 7(1), 128–134.

Muchammad. (2018). Analisis Pemanfaatan Limbah Sampah Plastik Jenis Polypropylene Menjadi Bahan Bakar Alternatif. Jurnal Ilmiah Momentum, 14(1),69–74. https://doi.org/http://dx.doi.org/10.36499/jim.v14i1.2189

Mulyono, T. (2004). Teknologi Beton (1st ed.). Andi.

Safitri, P. A., Purba, W. S., & Zulkifli, M. (2018). Statistik Lingkungan Hidup Indonesia (S. S. L. Hidup (ed.)). Badan Pusat Statistik.

Surahyo, A. (2019). Concrete Construction (1st ed). Springer International Publishing.

Syahputra, M. (2012). Optimasi Pemanfaatan Limbah Plastik Berjenis Polypropylene Sebagai Serat Pada Sifat Mekanis dan Pola Retak Beton. Repositori Institusi Universitas Sumatera Utara.

Winarto, S. (2017). Pemanfaatan Serat Ijuk Sebagai Material Campuran Dalam Beton Untuk Meningkatkan Kemampuan Beton Menahan Beban Tekan. Studi Kasus: Pembangunan Homestay Singonegaran Kediri. UKaRsT, 1(1), 1–10. https://doi.org/http://dx.doi.org/10.30737/u%20karst.v1i1.79

Downloads

Published

2021-06-30