THE SIMULATION AND DATA ANALYSIS OF TEMPERATURE SENSOR

Authors

  • Hilal Fauzi Ramadhan Departemen Fisika, FMIPA, IPB, Kampus IPB Dramaga Bogor, Jawa Barat, Indonesia, 16680
  • Retno Dwi Kartika Sari Departemen Fisika, FMIPA, IPB, Kampus IPB Dramaga Bogor, Jawa Barat, Indonesia, 16680
  • Adnan Prasetyo Alamsyah Departemen Fisika, FMIPA, IPB, Kampus IPB Dramaga Bogor, Jawa Barat, Indonesia, 16680
  • Adrian Fadhillah Departemen Fisika, FMIPA, IPB, Kampus IPB Dramaga Bogor, Jawa Barat, Indonesia, 16680
  • Rizki Nurhikmah Departemen Fisika, FMIPA, IPB, Kampus IPB Dramaga Bogor, Jawa Barat, Indonesia, 16680
  • Sarah Aribah Miftahulfallah Departemen Fisika, FMIPA, IPB, Kampus IPB Dramaga Bogor, Jawa Barat, Indonesia, 16680
  • Widya Rahma Departemen Fisika, FMIPA, IPB, Kampus IPB Dramaga Bogor, Jawa Barat, Indonesia, 16680
  • Ari Firia Departemen Fisika, FMIPA, IPB, Kampus IPB Dramaga Bogor, Jawa Barat, Indonesia, 16680
  • Dea Amelia Saputri Departemen Fisika, FMIPA, IPB, Kampus IPB Dramaga Bogor, Jawa Barat, Indonesia, 16680
  • Irmansyah Irmansyah Departemen Fisika, FMIPA, IPB, Kampus IPB Dramaga Bogor, Jawa Barat, Indonesia, 16680
  • Irzaman Irzaman Departemen Fisika, FMIPA, IPB, Kampus IPB Dramaga Bogor, Jawa Barat, Indonesia, 16680

DOI:

https://doi.org/10.21009/SPEKTRA.062.06

Keywords:

data simulation, temperature sensor, heating, cooling

Abstract

The study have successfully simulated 40 units data of temperature sensor during heating process and cooling process. Simulated data in temperature sensor has interval time 3 to 18 seconds for 5 iterations that are combined with other 7 data temperature sensor until get 40 data iterations. The data which has been simulated and then plotted into a graph with the x-axis is time and y-axis is average  heating process or cooling process. The graph formmed cupped-down with quadratic function for heating process and cupped-up for cooling process.

References

A. Bakker and J. H. Huijsing, “Micropower CMOS temperature sensor with digital output,” IEEE J. Solid-State Circuits, vol. 31, no. 7, pp. 933–937, 1996.
B. Larrió.n, M. Hernáez, F. J. Arregui, J. Goicoechea, J. Bravo, and I. R. Matías, “Photonic Crystal Fiber Temperature Sensor Based on Quantum Dot Nanocoatings,” J. Sensors, vol. 2009, 2009.
B. Musa, Y. M. Kamil, M. H. Abu Bakar, A. S. Mohd Noor, A. Ismail, and M. A. Mahdi, “Investigating the effect of taper length on sensitivity of the tapered-fiber based temperature sensor,” J. Teknol., vol. 78, no. 3, pp. 135–140, 2016.
C. Ma, S. R. Fassnacht, and S. K. Kampf, “How Temperature Sensor Change Affects Warming Trends and Modeling: An Evaluation Across the State of Colorado,” Water Resour. Res., vol. 55, no. 11, pp. 9748–9764, Nov. 2019.
C. Xin and M. Guan, “The sensitivity of distributed temperature sensor system based on Raman scattering under cooling down, loading and magnetic field,” Cryogenics (Guildf)., vol. 100, pp. 36–40, 2019.
D. Niu et al., “High-resolution and fast-response optical waveguide temperature sensor using asymmetric Mach-Zehnder interferometer structure,” Sensors Actuators, A Phys., vol. 299, 2019.
E. Bin Park, S. J. M. Yazdi, and J. H. Lee, “Development of wearable temperature sensor based on peltier thermoelectric device to change human body temperature,” Sensors Mater., vol. 32, no. 9, pp. 2959–2970, 2020.
F. N. Hamada et al., “An internal thermal sensor controlling temperature preference in Drosophila,” Nature, vol. 454, no. 7201, pp. 217–220, 2008.
G. Liu et al., “A flexible temperature sensor based on reduced graphene oxide for robot skin used in internet of things,” Sensors (Switzerland), vol. 18, no. 5, 2018.
H. Fu, S. Wang, H. Chang, and Y. You, “A high resolution and large range fiber Bragg grating temperature sensor with vortex beams,” Opt. Fiber Technol., vol. 60, 2020.
J. Gong et al., “High sensitivity fiber temperature sensor based PDMS film on Mach Zehnder interferometer,” Opt. Fiber Technol., vol. 53, 2019.
J. Gong et al., “High sensitivity fiber temperature sensor based PDMS film on Mach Zehnder interferometer,” Opt. Fiber Technol., vol. 53, 2019.
J. Jeon, H. B. R. Lee, and Z. Bao, “Flexible wireless temperature sensors based on Ni microparticle-filled binary polymer composites,” Adv. Mater., vol. 25, no. 6, pp. 850–855, Feb. 2013.
J. Shin et al., “Sensitive Wearable Temperature Sensor with Seamless Monolithic Integration,” Adv. Mater., vol. 32, no. 2, Jan. 2020.
J. W. Sanders, J. Yao, and H. Huang, “Microstrip Patch Antenna Temperature Sensor,” IEEE Sens. J., vol. 15, no. 9, pp. 5312–5319, 2015.
L. Urgoiti, D. Barrenetxea, J. A. Sánchez, I. Pombo, and J. Álvarez, “On the influence of infra-red sensor in the accurate estimation of grinding temperatures,” Sensors (Switzerland), vol. 18, no. 12, 2018.
M. F. Moreira, I. C. S. Carvalho, W. Cao, C. Bailey, B. Taheri, and P. Palffy-Muhoray, “Cholesteric liquid-crystal laser as an optic fiber-based temperature sensor,” Appl. Phys. Lett., vol. 85, no. 14, pp. 2691–2693, Oct. 2004.
M. K. Law and A. Bermak, “A 405-nW CMOS temperature sensor based on linear MOS operation,” IEEE Trans. Circuits Syst. II Express Briefs, vol. 56, no. 12, pp. 891–895, 2009.
M. Nitani, K. Nakayama, K. Maeda, M. Omori, and M. Uno, “Organic temperature sensors based on conductive polymers patterned by a selective-wetting method,” Org. Electron., vol. 71, pp. 164–168, 2019.
M. V. Andrés, S. Torres-Peir, A. Díez, and J. L. Cruz, “Temperature sensor based on ge doped microstructured fibers,” J. Sensors, vol. 2009, 2009.
N. L. Marpaung, R. Amri, E. Ervianto, and N. Dani Ali, “Analysis of Controlling Wireless Temperature Sensor for Monitoring Peat-Land Fire,” Int. J. Electr. Energy Power Syst. Eng., vol. 1, no. 2, pp. 14–19, 2018.
P. Chang et al., “The temperature responsive mechanism of fiber surface plasmon resonance sensor,” Sensors Actuators, A Phys., vol. 309, 2020.
R. Perkasa, R. Wahyuni, R. Melyanti, H. Herianto, and Y. Irawan, “Light Control Using Human Body Temperature Based on Arduino Uno and PIR (Passive Infrared Receiver) Sensor,” J. Robot. Control, vol. 2, no. 4, 2021.
R. Zhao, G. Shao, N. Li, C. Xu, and L. An, “Development of a Wireless Temperature Sensor Using Polymer-Derived Ceramics,” J. Sensors, vol. 2016, 2016.
S. Augustin and T. Fröhlich, “Temperature dependence of the dynamic parameters of contact thermometers,” Sensors (Switzerland), vol. 19, no. 10, 2019.
S. Kim, M. R. Adib, and K. Lee, “Development of chipless and wireless underground temperature sensor system based on magnetic antennas and SAW sensor,” Sensors Actuators, A Phys., vol. 297, 2019.
S. Sarma and J. H. Lee, “Developing efficient thin film temperature sensors utilizing layered carbon nanotube films,” Sensors (Switzerland), vol. 18, no. 10, 2018.
S. Y. Hong et al., “Stretchable Active Matrix Temperature Sensor Array of Polyaniline Nanofibers for Electronic Skin,” Adv. Mater., vol. 28, no. 5, pp. 930–935, Feb. 2016.
T. Q. Trung, S. Ramasundaram, B.-U. Hwang, and N.-E. Lee, “An All-Elastomeric Transparent and Stretchable Temperature Sensor for Body-Attachable Wearable Electronics ,” Adv. Mater., vol. 28, no. 3, pp. 394–394, Jan. 2016.
W. Li, X. Sha, D. An, and Z. Li, “A microring temperature sensor based on the surface plasmon wave,” Adv. Optoelectron., vol. 2015, 2015.
W. P. Shih et al., “Flexible temperature sensor array based on a Graphite Polydimethylsiloxane composite,” Sensors, vol. 10, no. 4, pp. 3597–3610, 2010.
X. Fu, Y. Zhang, Y. Wang, G. Fu, W. Jin, and W. Bi, “A temperature sensor based on tapered few mode fiber long-period grating induced by CO2 laser and fusion tapering,” Opt. Laser Technol., vol. 121, 2020.
X. Ren, P. K. L. Chan, J. Lu, B. Huang, and D. C. W. Leung, “High Dynamic Range Organic Temperature Sensor,” Adv. Mater., vol. 25, no. 9, pp. 1290–1290, Mar. 2013.
Y. Du et al., “High-sensitivity refractive index and temperature sensor based on cascading FBGs and droplet-like fiber interferometer,” Sensors Actuators, A Phys., vol. 299, 2019.
Y. He, “Rapid thermal conductivity measurement with a hot disk sensor: Part 1. Theoretical considerations,” Thermochim. Acta, vol. 436, no. 1–2, pp. 122–129, 2005.
Y. L. Lo, W. T. Chen, Y. T. Chiu, and W. Bin Yang, “A high-resolution all-digital temperature sensor with process variation compensation,” Sensors Mater., vol. 28, no. 5, pp. 395–402, 2016.
Y. Liu and L. B. Yuan, “Ultrasensitive temperature sensor based on a urethane acrylate coated off-axis spiral long period fiber grating,” Optik (Stuttg)., vol. 223, 2020.
Y. S. Lin, D. Sylvester, and D. Blaauw, “An ultra low power 1V, 220nW temperature sensor for passive wireless applications,” in Proceedings of the Custom Integrated Circuits Conference, 2008, pp. 507–510.
Y. Wang, Y. Jia, Q. Chen, and Y. Wang, “A passive wireless temperature sensor for harsh environment applications,” Sensors, vol. 8, no. 12, pp. 7982–7995, 2008.
Z. Cao, X. Wei, L. Zhao, Y. Chen, and M. Yin, “Investigation of SrB4O7:Sm2+ as a Multimode Temperature Sensor with High Sensitivity,” ACS Appl. Mater. Interfaces, vol. 8, no. 50, pp. 34546–34551, Dec. 2016.
R. T. Kusuma et al., “Characteristics of Thermistors as Temperature Sensors on the Sensor Unit (SU 6803) and OP Amp Unit(OU-6801),” AIP Conference Proceedings, vol. 2320, no 1, pp. 050011, Mar 2021.
Anonymous. Sensor Application Trainer: Temperature sensors on the Sensor Unit (SU-6803) and OP Amp Unit (OU-6801). AD Instruments. www.adinstruments.es.

Downloads

Published

2021-10-30

How to Cite

Ramadhan, H. F. ., Sari, R. D. K. ., Alamsyah, A. P. ., Fadhillah, A. ., Nurhikmah, R. ., Miftahulfallah, S. A. ., … Irzaman, I. (2021). THE SIMULATION AND DATA ANALYSIS OF TEMPERATURE SENSOR. Spektra: Jurnal Fisika Dan Aplikasinya, 6(2), 129–136. https://doi.org/10.21009/SPEKTRA.062.06

Most read articles by the same author(s)