Vol. 10 No. 1 (2025)

View Vol. 10 No. 1 (2025)

SUMMARY. Suryadi et al., in their paper, a rejuvenation and modernization of the control system were carried out by applying a proportional, integral and differential (PID) control system. Lesmana et al., in their paper, employs an experimental method using various 3D print speed settings (70, 80, and 90 mm/s) and layer heights (0.15 and 0.20 mm). Rohmatin et al., in their paper, identify the cassava chip production process and analyze the production planning of cassava chips in business houses. Setiawan et al., in their paper, conducted analyze the turbine speed triangle at an entry angle of 12-14° from the results of the technical design. Wiradinata et al., in their paper, investigates the corrosion rate of low-carbon steel ASTM A36 and AISI 1020 in sulfuric acid solution under varying heat treatment temperatures and immersion times. Gulo et al., in their paper, analyze the effect of print speed and nozzle temperature variations on the tensile strength of TPU-95A material printed using the fused deposition modeling (FDM) method. Putra et al., in their paper, analyzing the structural strength of car deck construction in roll-on/roll-off (ro-ro) passenger ships. Kusuma et al., in their paper, a review four main types of EVs: battery electric vehicles (BEVs), plug-in hybrid electric vehicles (PHEVs), hybrid electric vehicles (HEVs), and fuel cell electric vehicles (FCEVs). Efendi et al., in their paper, discusses the comparison of efficiency between solar PV fixed, single-axis solar trackers, and dual-axis solar trackers.

DOI: https://doi.org/10.21009/10.21009/JKEM.10.1
Published: 2025-01-31

Articles